SAM Installation: File Transfer Protocols
You must install the sam_cp and sam_cp_config
wrappers, and at least one of the specific supported underlying protocols:
- sam_gridftp:
- this replaces bbftp for inter-site transfers
- wrapper around gridftp for use by the 'sam' account, specifically for sam transfers
- sam_bbftp:
- will be phased out and replaced by sam_gridftp
- wrapper around bbftp for use by the 'sam' account, specifically for sam transfers
- sam_kerberos_rcp:
- most on-site Fermilab nodes will use this also
- wrapper around kerberized rcp for use by the 'sam' account, specifically for sam transfers
- sam_encp:
- only a limited number of on-site Fermilab nodes will use this
- wrapper around transfers to/from D0's Enstore installation
- Installing and Configuring the sam_cp wrapper:
- Tailoring sam_cp_config:
- Installing and Configuring sam_gridftp:
- Installing and Configuring sam_bbftp:
- Installing and Configuring sam_kerberos_rcp:
- Installing sam_encp: